以广州市为例,基于城市感知数据、遥感影像等多源数据,采用卷积神经网络对遥感影像进行了语义提取,将提取结果与兴趣点（Points of Interest）样方密度的功能用地识别结果进行补充校验,根据政策和规划文件建立功能用地与主体功能区之间的关联,利用信息熵分析广州市功能用地混合程度,以辅助判别主体功能区,最终得到广州市主体功能区划分结果。将划分结果与《广州市主体功能区规划（2008—2020年）》和《广州市城市总体规划（2017—2035年）》草案对比验证,结果表明文章所提出的方法精准度较高,并能体现广州市空间格局形态,反映主体功能区实际分布情况。 相似文献
ENSO is an interannual mode which may be affected by external forcing, such as volcanic eruptions. Based on the reconstructed volcanic eruptions chronology and ENSO sequences, both 195 large volcanic eruptions(VEI≥4) and 398 ENSO(El Ni?o and La Ni?a) events were extracted from 1525 to 2000. An analysis of the correspondence between the large volcanic eruptions and ENSO events was performed by matching the large volcanic eruptions with the types and magnitudes of ENSO events present in the 0–2 years after the eruptions. The results show the following:(1) The percentages of ENSO events within the 3 years after the large eruptions had increased to 68.3% from 31.7% compared with those with no-eruptions in the previous 0–2 years. In addition, the ratio of El Ni?o to La Ni?a events turned from 2:3 to 1:1, and more El Ni?o events occurred in the 0 year after eruptions in the low-latitudes of the Northern Hemisphere and in the tropics but more La Ni?a events occurred in the 0 year after in the high-latitudes of the Northern Hemisphere and the Southern Hemisphere.(2) After the eruptions, the weak(W) El Ni?o events had increased by 8 percentage points and the very strong(VS) El Ni?o events had decreased by 10 percentage points; conversely, there was a decrease by 15 percentage points of the weak La Ni?a events and an increase by 11.4 percentage points of the very strong La Ni?a events. Specifically, the percentages of strong La Ni?a events increased to a peak at 1(+1) year after the eruptions.(3) The percentage of eruptions followed by single-year ENSO was the greatest. The percentage of ENSO events that occurred in the consecutive 2 years following an eruption was approximately equal to the percentage of events that occurred consecutively 3 years following an eruption, and both sets of ENSO magnitudes showed a decreasing trend. 相似文献
Urbanization and eco-environment coupling is a research hotspot.Dynamic simulation of urbanization and eco-environment coupling needs to be improved because the processes of coupling are complex and statistical methods are limited.Systems science and cross-scale coupling allow us to define the coupled urbanization and eco-environment system as an open complex giant system with multiple feedback loops.We review the current state of dynamic simulation of urbanization and eco-environment coupling and find that:(1)The use of dynamic simulation is an increasing trend,the relevant theory is being developed,and modeling processes are being improved;(2)Dynamic simulation technology has become diversified,refined,intelligent and integrated;(3)Simulation is mainly performed for three aspects of the coupling,multiple regions and multiple elements,local coupling and telecoupling,and regional synergy.However,we also found some shortcomings:(1)Basic theories are inadequately developed and insufficiently integrated;(2)The methods of unifying systems and sharing data are behind the times;(3)Coupling relations and the dynamic characteristics of the main driving elements are not fully understood or completely identified.Additionally,simulation of telecoupling does not quantify parameters and is not systemically unified,and therefore cannot be used to represent spatial synergy.In the future,we must promote communication between research networks,technology integration and data sharing to identify the processes governing change in coupled relations and in the main driving elements in urban agglomerations.Finally,we must build decision support systems to plan and ensure regional sustainable urbanization. 相似文献
Journal of Geographical Sciences - To understand the non-equilibrium morphological adjustment of a river in response to environmental changes, it is essential to (i) accurately identify how past... 相似文献
Methane content in coal seam is an essential parameter for the assessment of coalbed gas reserves and is a threat to underground coal mining activities. Compared with the adsorption-isotherm-based indirect method, the direct method by sampling methane-bearing coal seams is apparently more accurate for predicting coalbed methane content. However, the traditional sampling method by using an opened sample tube or collecting drill cuttings with air drilling operation would lead to serious loss of coalbed methane in the sampling process. The pressurized sampling method by employing mechanical-valve-based pressure corer is expected to reduce the loss of coalbed methane, whereas it usually results in failure due to the wear of the mechanical valve. Sampling of methane-bearing coal seams by freezing was proposed in this study, and the coalbed gas desorption characteristics under freezing temperature were studied to verify the feasibility of this method. Results show that low temperature does not only improve the adsorption velocity of the coalbed gas, but also extend the adsorption process and increase the total adsorbed gas. The total adsorbed methane gas increased linearly with decreasing temperature, which was considered to be attributed to the decreased Gibbs free energy and molecular average free path of the coalbed gas molecular caused by low temperature. In contrast, the desorption velocity and total desorbed gas are significantly deceased under lower temperatures. The process of desorption can be divided into three phases. Desorption velocity decreases linearly at the first phase, and then, it shows a slow decreases at the second phase. Finally, the velocity of desorption levels off to a constant value at the third phase. The desorbed coalbed gas shows a parabolic relation to temperature at each phase, and it increases with increasing temperature at the first phase, and then, it poses a declining trend with increasing temperature at the rest phases. The experimental results show that decreasing the system temperature can restrain desorption of coalbed methane effectively, and it is proven to be a feasible way of sampling methane-bearing coal seams.
